Jump to content

Talk:Engineering validation test

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia
This is an old revision of this page, as edited by Widefox (talk | contribs) at 13:05, 11 May 2019 (Assessment: +Engineering: class=Start, importance=Low (assisted)). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.
WikiProject iconEngineering Start‑class Low‑importance
WikiProject iconThis article is within the scope of WikiProject Engineering, a collaborative effort to improve the coverage of engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.
StartThis article has been rated as Start-class on Wikipedia's content assessment scale.
LowThis article has been rated as Low-importance on the project's importance scale.

Is an Engineering verification test the same as an Engineering validation test? Biscuittin (talk) 17:51, 23 November 2009 (UTC)[reply]

This article does not specify the relationship between Engineering Verification Test and Design Verification Test either. In the section on Design Verification Test, it first says that it comprehends five areas but then it lists a greater number of bullet points. —Preceding unsigned comment added by Alex Pascual (talkcontribs) 16:43, 3 July 2010 (UTC)[reply]

In the section on Design Refinement there is a sentence that defines DVT. No such definition exists in the DVT section. I'll move this sentence from the "Design Refinement" section to the "Design Verification Test" section. —Preceding unsigned comment added by Alex Pascual (talkcontribs) 16:50, 3 July 2010 (UTC)[reply]

Knowledge Aquistion

Can some one give me detail knowledge about EV and DV in deapth ( Email dipesh0001@indiatimes.com) —Preceding unsigned comment added by Dipesh0001 (talkcontribs) 05:30, 8 October 2010 (UTC)[reply]