This is an old revision of this page, as edited by LightYear(talk | contribs) at 22:42, 12 December 2012(Explained my delete in the Usage section). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.Revision as of 22:42, 12 December 2012 by LightYear(talk | contribs)(Explained my delete in the Usage section)
This article is within the scope of WikiProject Mathematics, a collaborative effort to improve the coverage of mathematics on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MathematicsWikipedia:WikiProject MathematicsTemplate:WikiProject Mathematicsmathematics
This article is within the scope of WikiProject Physics, a collaborative effort to improve the coverage of Physics on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.PhysicsWikipedia:WikiProject PhysicsTemplate:WikiProject Physicsphysics
This article is within the scope of WikiProject Electrical engineering, a collaborative effort to improve the coverage of Electrical engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.Electrical engineeringWikipedia:WikiProject Electrical engineeringTemplate:WikiProject Electrical engineeringelectrical engineering
I deleted the following from the page because I believe it's nonsense (the RMS is the DC equivalent, not the form factor). I've preserved it here in case it was valuable to someone. LightYear (talk) 22:42, 12 December 2012 (UTC)[reply]
The form factor can be multiplied by an alternating current's peak voltage or current to provide the direct current equivalent in terms of power.
and .
Conversely, it can be used to divide a DC value, giving the peak AC value needed to provide the same power.
.jpg?lang=en){kind=small}
