Talk:Push–pull output

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic
???	This article has not yet received a rating on Wikipedia's content assessment scale.
???	This article has not yet received a rating on the project's importance scale.

Drawing Request

It would be amazing to have an actual drawing of a totem-pole schematic here :)

Be amazed. Dicklyon (talk) 22:22, 14 April 2011 (UTC)[reply]

Too bad it's not illustrating a push-pull output. I don't know what it's illustrating. PNP and NPN transistors? Collector of one hooked to the emitter of the other? It'd be nice to acknowledge the bias problem, as well. An incorrect picture is worse than no picture. --Wtshymanski (talk) 13:20, 14 September 2011 (UTC)[reply]

Better picture found, showing + and - power supplies and load, also a tube-type amp schematic with center-tapped transformer. --Wtshymanski (talk) 15:32, 14 September 2011 (UTC)[reply]

Expansion

As usual, no history - push-pull amplifiers are designed with out comment in the 1945 Radiotron handbook, so doubtless the technique is nearly as old as vacuum tubes. I've tried to put in some explanation as to *why* you would want these various perversions in a circuit, but I can't find any history yet. --Wtshymanski (talk) 21:43, 29 November 2012 (UTC)[reply]

Colpitts didn't claim the push-pull principle in 1915 and that's running pretty far back into tube history; one book suggests that carbon microphone capsules were used as telephone circuit amplifiers in push-pull, so maybe it wasn't considered a patentable innovation. --Wtshymanski (talk) 21:17, 30 November 2012 (UTC)[reply]