Parallel Peripheral Interface

The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

The Parallel Peripheral Interface (PPI) is a peripheral found on the Blackfin embedded processor. The PPI is a half-duplex, bi-directional port that is designed to connect directly to LCDs, CMOS sensors, CCDs, video encoders (video DACs), video decoders (video ADCs) or any generic high speed, parallel device.^[1]

The width of the PPI is programmable and can be set between 8 and 16 bits in 1-bit increments. The latest Blackfin family (BF54x) also features an 18/24-bit PPI for direct connection to RGB LCD panels.

The PPI can run from 0 MHz up to 66 MHz.

The PPI has a dedicated clock pin, three multiplexed frame sync pins, and between 16 and 24 data pins.^[2]

References

^ "PPI: Parallel Peripheral Interface [Analog Devices Wiki]". wiki.analog.com. Retrieved 2021-10-01.
^ Y, Roshni (2019-07-04). "What is 8255 Programmable Peripheral Interface (PPI)? Definition, Architecture, Pin Diagram and Modes of Operation of 8255". Electronics Desk. Retrieved 2021-10-01.

http://blackfin.uclinux.org/doku.php?id=ppi

This computer hardware article is a stub. You can help Wikipedia by expanding it.

[1] "PPI: Parallel Peripheral Interface [Analog Devices Wiki]". wiki.analog.com. Retrieved 2021-10-01.

[2] Y, Roshni (2019-07-04). "What is 8255 Programmable Peripheral Interface (PPI)? Definition, Architecture, Pin Diagram and Modes of Operation of 8255". Electronics Desk. Retrieved 2021-10-01.

[1]

[2]