Jump to content

MLT-3 encoding

From Wikipedia, the free encyclopedia
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
Example of MLT-3 Encoding. Light-colored lines indicate two previous states, where : 133710 = 101001110012

MLT-3 encoding (Multi-Level Transmit) is a line code (a signaling method used in a telecommunication system for transmission purposes) that uses three voltage levels. An MLT-3 interface emits less electromagnetic interference and requires less bandwidth than most other binary or ternary interfaces that operate at the same bit rate (see PCM for discussion on bandwidth / quantization tradeoffs), such as Manchester code or Alternate Mark Inversion.

Eye pattern of a MLT-3 signal

MLT-3 cycles sequentially through the voltage levels −1, 0, +1, 0. It moves to the next state to transmit a 1 bit, and stays in the same state to transmit a 0 bit. Similar to simple NRZ encoding, MLT-3 has a coding efficiency of 1 bit/baud, however it requires four transitions (baud) to complete a full cycle (from low-to-middle, middle-to-high, high-to-middle, middle-to-low). Thus, the maximum fundamental frequency is reduced to one fourth of the baud rate. This makes signal transmission more amenable to copper wires.

The lack of transition on a 0 bit means that for practical use, the number of consecutive 0 bits in the transmitted data must be bounded; i.e. it must be pre-coded using a run-length limited code. This results in an effective bitrate slightly lower than one bit per baud or four bits per cycle.

MLT-3 was first introduced by Crescendo Communications[1] as a coding scheme for FDDI copper interconnect (TP-PMD,[2] aka CDDI). Later, the same technology was used in the 100BASE-TX physical medium dependent sublayer, given the considerable similarities between FDDI and 100BASE-[TF]X physical media attachment layer (section 25.3 of IEEE802.3-2002 specifies that ANSI X3.263:1995 TP-PMD should be consulted, with minor exceptions).

Signaling specified by 100BASE-T4 Ethernet, while it has three levels, is not compatible with MLT-3. It uses selective base-2 to base-3 conversion with direct mapping of base-3 digits to line levels (8B6T code).

See also

References

  1. ^ [1], Network World, June 29, 1992, page 19
  2. ^ American National Standards Institute (1994). "FDDI twisted pair physical layer medium dependent (TP-PMD)". American National Standard X3T12 (Incorporates X3.263). - initial implementation; also see patent
Stub icon

This article related to telecommunications is a stub. You can help Wikipedia by expanding it.

Retrieved from "https://en.wikipedia.org/w/index.php?title=MLT-3_encoding&oldid=1224965742"