Jump to content

Talk:BASIC interpreter

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia
This is an old revision of this page, as edited by SineBot (talk | contribs) at 22:59, 1 August 2020 (Signing comment by 47.203.144.219 - "PEEK/POKE"). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

The article is missing the following, at the least:

  • Useful diagram summarizing the typical architecture of a BASIC interpreter
  • Discussion of the earliest BASIC interpreters, which were written for minicomputers
  • Discussion of two interpreters that predated Altair BASIC:
    • One a government-funded project, programmed on a minicomputer for an 8008
    • SCELBAL, for the 8008
  • The ANSI standardization of BASIC
  • Support for computed GOTO, in Integer BASIC as well as Tiny BASIC (e.g., GOTO 100*X instead of ON X GOTO 100, 200, 300)
  • Add note about new graphic commands, perhaps starting with Level I
  • Memory maps
  • PEEK/POKE — Preceding unsigned comment added by 47.203.144.219 (talk) 22:58, 1 August 2020 (UTC)[reply]
  • Update bibliography; add Further Reading with annotated source for PATB, Altair, Atari BASIC, and Integer BASIC

Done:

  • Add table contrasting extent of tokenization

--Jeffrey Henning (talk) 04:02, 1 August 2020 (UTC)[reply]