QSA and QRK radio signal reports
The QSA code and QRK code are interrelated and complimentary signal reporting codes for use in wireless telegraphy (Morse code). An enhanced format, SINPO code, was published in the ITU Radio Regulations, Geneva, 1959,[1] but is longer and unwieldy for use in the fast pace of Morse code communications.
Current format
The current definition of the QSA and QRK codes are officially defined in ITU Radio Regulations 1990, Appendix 13: Miscellaneous Abbreviations and Signals to Be Used in Radiotelegraphy Communications Except in the Maritime Mobile Service, and are also described identically in ACP131(F),[2]:
| Signal | Question | Answer, Advice, or Order |
|---|---|---|
| QRK | What is the intelligibility of my signals (or those of...)? | The intelligibility of your signals (or those of...) is...
|
| QSA | What is the strength of my signals (or those of...)? | The strength of your signals (or those of...) is...
|
Historical development
The QSK code is one of the earliest signal reporting formats and is a part of the Q code used for commercial radiotelegraph communication, appearing as one of the twelve Q Codes listed in the 1912 International Radiotelegraph Convention Regulations, and was later adopted by other radio services, especially amateur radio. The QSA code was mandated by the Madrid Convention (Appendix 10, General Regulations) sometime prior to 1936, and specified the following reporting format, as found in the 1936 edition of the ARRL's The Radio Amateur's Handbook[3] and Radiotelegraph & Radiotelephone Codes, Prowords and Abbreviations.[1]
| Request from first station | Response from receiving station | Meaning |
|---|---|---|
| QRK (replaced earlier QJS) | QSA1 | Hardly perceptible, unreadable |
| QSA2 | Weak, readable now and then | |
| QSA3 | Fairly good, readable but with difficulty | |
| QSA4 | Good, readable | |
| QSA5 | Very good, perfectly readable |
The book goes on to note that "Some of the definitions, however, appear to confuse audibility or signal strength with readability, which may be impaired even when signals are strong, by atmospherics, interference, a noisy receiver, etc.", and that because of this Amateurs supplemented the QSA system reports with a readability scale, called the R-System, which used a scale of 1 to 9. The book describes the QSA- and R-systems immediately after describing the R-S-T system, and notes that the R-S-T report format, because it is three digits long, cannot be confused with either of the earlier systems. The book does not clarify the method for requesting an R-S-T report instead of a QSA report.[3]
An expanded QRK code was first defined to go along with the earlier QSA code in the ITU Radio Regulations Cairo, 1938.[1]
| Request from first station | Response from receiving station | Meaning |
|---|---|---|
| QSA (replaced earlier QJS) | QSA1 | Hardly perceptible, unreadable |
| QSA2 | Weak, readable now and then | |
| QSA3 | Fairly good, readable but with difficulty | |
| QSA4 | Good, readable | |
| QSA5 | Very good, perfectly readable |
| Request from first station | Response from receiving station | Meaning |
|---|---|---|
| QRK | R1 | Unreadable |
| R2 | Occasional words distinguishable | |
| R3 | Readable with difficulty | |
| R4 | Readable with almost no difficulty | |
| R5 | Perfectly readable |
FM 24-6 Radiotelegraph signal report format
The 1945 U.S. Army Radio Operator's Manual, FM 24-6 defines the radiotelegraph signal report format as follows:[4]
| Report | Readability | Signal Strength |
|---|---|---|
| 1 | Unreadable | Scarcely perceptible |
| 2 | Readable now and then | Weak |
| 3 | Readable but with difficulty | Fairly good |
| 4 | Readable | Good |
| 5 | Perfectly readable | Very good |
FM 24-6 further states, "Readability and signal strength reports indicate the desired method of transmission and should be used in that sense. Readability and signal strength reports are not exchanged unless "3" or less, lack of any report being assumed to indicate satisfactory communications."
The report example given below uses military call signs and the obsolete Q Code of QJS for readability instead of the current QRK:
| Station | Transmission |
|---|---|
| MB6 | 3MY V MB6 QJS 3 K |
| 3MY | MB6 V 3MY INT QJS K |
| MB6 | 3MY V MB6 QJS 4 AR |
| MB6 | S7P V MB6 INT QJS INT QSA K |
| S7P | MB6 V S7P QJS 3 QSA 3 AR |
See also
- Other signal reporting codes
- Signal strength and readability report
- SINPO code
- R-S-T system (for Amateur radio only)
- Circuit Merit (for wired telephone circuits only)
- Plain language radio checks
References
- ^ a b c "Radiotelegraph & Radiotelephone Codes, Prowords and Abbreviations".
{{cite web}}: Cite has empty unknown parameter:|dead-url=(help) - ^ "ACP 131(F) - Communications Instructions Operating Signals, April 2009" (PDF). Archived from the original (PDF) on September 6, 2012.
{{cite web}}: Unknown parameter|deadurl=ignored (|url-status=suggested) (help) - ^ a b The Radio Amateur's Handbook (PDF). ARRL. 1936. p. 364.
- ^ War Department Field Manual: Radio Operator's Manual. United States War Department. 1945.