Talk:Minimum detectable signal

Radio Unassessed

This article is within the scope of WikiProject Radio, a collaborative effort to improve the coverage of Radio-related subjects on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.RadioWikipedia:WikiProject RadioTemplate:WikiProject RadioRadio

???

This article has not yet received a rating on Wikipedia's content assessment scale.

???

This article has not yet received a rating on the project's importance scale.

To-do List:

Here are some tasks awaiting attention:

Article requests : Create: Missing years and articles in radio, National Association of Radio Distress-Signalling and Infocommunications (Hungary)
Assess : Unassessed Radio articles; Unknown-importance Radio articles
Cleanup : Radio articles needing attention
Expand : Midweek Politics Bob Crane
Maintain : Portal:Radio
Stubs : Expand: Radio stubs
Verify : Unreferenced BLPs
Other : Collaboration of the Week:
Requests for Radio peer review:

Wrong Formula

The formula presented on this page always applies a constant noise figure for a given bandwidth. It should apply the noise in 1Hz to the bandwidth.

MDS (dBW) = 10log10((kT/1mW) * Bandwidth) + (noise figure, dB)+ SNRout (dB) — Preceding unsigned comment added by 92.28.190.8 (talk) 07:18, 28 April 2013 (UTC)[reply]

confusing sentence

I find this sentence: "Any signal of lower power may not be discerned from noise, except for specific situations." to be quite confusing. The article correctly states in the opening that to reasonably talk about this, one needs to define what it means to detect a signal, i.e. required SNR but also the integration time of the observation. If I have a (constant) signal 3dB below the noise floor of my device and observe it for an hour, it will be easily visible. Scummos (talk) 10:57, 10 January 2015 (UTC)[reply]