Direct-coupled transistor logic

Direct-coupled transistor logic (DCTL) is similar to resistor–transistor logic (RTL) but without the base input resistors: the input transistor bases are connected directly the collector outputs without any base resistors. Consequently, DCTL gates have fewer components, are more economical, and are simpler to fabricate onto integrated circuits than RTL gates. Unfortunately, DCTL has much smaller signal levels, has more susceptibility to ground noise, and requires matched transistor characteristics. The transistors are also heavily overdriven; that is a good feature in that it reduces the saturation voltage of the output transistors, but it also slows the circuit down due to a high stored charge in the base.^[1] Gate fan-out is limited due to "current hogging": if the transistor base-emitter voltages ( $V BE$ ) are not well matched, then the base-emitter junction of one transistor may conduct most of the input drive current at such a low base-emitter voltage that other input transistors fail to turn on.^[2]

References

^ Roehr 1963, p. 36
^ Roehr 1963, p. 37

Roehr, William, ed. (1963), Switching Transistor Handbook, Motorola, Inc.

External links

www.antiquetech.com

This electronics-related article is a stub. You can help Wikipedia by expanding it.

[1] Roehr 1963, p. 36

[2] Roehr 1963, p. 37

[1]

[2]

v t e Logic families
MOS technology	PMOS logic NMOS logic Depletion-load NMOS logic (including HMOS) Complementary MOS (CMOS) Pass transistor logic (PTL) Bipolar–CMOS (BiCMOS)
Other technologies	Diode logic Diode–transistor logic (DTL) Open collector (OC) Direct-coupled transistor logic (DCTL) Emitter-coupled logic (ECL) Gunning transceiver logic (GTL) Integrated injection logic (I²L) Resistor–transistor logic (RTL) Transistor–transistor logic (TTL) Current mode logic / Source-coupled logic (CML/SCL)
Types	Static Dynamic Domino logic Four-phase logic