Jump to content

Carr index

From Wikipedia, the free encyclopedia
This is an old revision of this page, as edited by Realjimcarey (talk | contribs) at 19:54, 16 May 2012 (The equation was backwards and gives negative numbers in its present state. The edits have been made above. It should be 100*((Bulk Volume - Tapped Volume)/Bulk Volume)). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

The Carr index (also: Carr's index[1] or Carr's Compressibility Index[2]) is an indication of the compressibility of a powder. It is named after the pharmacologist Charles Jelleff Carr (1910–2005).[2][3]

The Carr index is calculated by the formula , where is the freely settled volume of a given mass of powder, and is the tapped volume of the same mass of powder. It can also be expressed as , where is the freely settled bulk density of the powder, and is the tapped bulk density of the powder.

The Carr index is frequently used in pharmaceutics as an indication of the flowability of a powder. A Carr index greater than 25 is considered to be an indication of poor flowability, and below 15, of good flowability.[4]

The Carr index is related to the Hausner ratio, another indication of flowability, by the formula .

Both the Hausner ratio and the Carr index are sometimes criticized, despite their relationships to flowability being established empirically, as not having a strong theoretical basis. Use of these measures persists, however, because the equipment required to perform the analysis is relatively cheap and the technique is easy to learn.

References

  1. ^ Bowker, Michael I. & P. Heinrich Stahl. 2008. "Preparation of Water-Soluble Compounds through Salt Formation." In Camille Georges Wermuth, ed. The Practice of Medical Chemistry, pp. 747–766. Burlington, MA: Elsevier, p. 756.
  2. ^ a b Podczeck, Fridun & Brian E. Jones, eds. 2007. Pharmaceutical Capsules. London: Pharmaceutical Press, p. 111.
  3. ^ In Memoriam: Charles Jelleff Carr, Ph.D., 1910–2005
  4. ^ Kanig, Joseph L.; Lachman, Leon; Lieberman, Herbert A. (1986). The Theory and Practice of Industrial Pharmacy (3 ed.). Philadelphia: Lea & Febiger. ISBN 0-8121-0977-5.{{cite book}}: CS1 maint: multiple names: authors list (link)

General Bibliography

Mark Gibson (2001). Pharmaceutical Preformulation and Formulation: A Practical Guide from Candidate Drug Selection to Commercial Dosage Form. Boca Raton: CRC Press. ISBN 1-57491-120-1.