Lofting coordinates
 | This article or section is in a state of significant expansion or restructuring. You are welcome to assist in its construction by editing it as well. If this article or section has not been edited in several days, please remove this template. If you are the editor who added this template and you are actively editing, please be sure to replace this template with {{in use}} during the active editing session. Click on the link for template parameters to use.
This article was last edited by Викидим (talk | contribs) 11 months ago. (Update timer) |
Lofting coordinates are used for aircraft body measurements. The system derives from the one that was used in the shipbuilding lofting process, with longitudinal axis labeled as "stations" (usually fuselage stations, frame stations, FS), transverse axis as "buttocks lines" (or butt lines, BL), and vertical axis as "waterlines" (WL). The lofting coordinate frame is similar, but not the same as aircraft principal axes used to describe the aircraft flight. For the US-manufactured aircraft the ticks on the axes are labeled in inches,[1] (for example, WL 100 is 100 inches above the base waterline).
Fuselage station
Fuselage stations are traditionally nonnegative, thus the origin is located at the nose of the plane or, sometimes, ahead of it. When compared to the coordinates used for aeromechanics, the fuselage stations are measured in the opposite direction than the ticks on the x-axis (and might not be aligned at all, if the wind-aligned coordinate system is used to describe the flight).[1]
Butt line
Butt line ticks increase to the right of the pilot with the origin at the centerline. When compared with the (right-handed) aeromechanics coordinate systems, the direction of the butt line is opposite to the y-axis.[1]
Waterline
Per US Air Force Airframe Maintenance and Repair Manual (1960), a waterline extends from the nose cone of the aircraft to the exhaust cone. The base line of the aircraft is designated as waterline 0 (zero). The location of this base line varies on different types of aircraft. However. the planes of all waterlines above and below the zero waterline are parallel.[2] The waterline number (WL or W.L.) in the US is expressed in inches, values increase upwards. Two typical alignments for the base line are the tip of the nose (negative WK are possible) or the "nominal ground plane" (measurements will be nonnegative).[3]
References
- ^ a b c Takahashi 2017, Coordinate Frames.
- ^ United States. Air Force 1960, p. 14-20.
- ^ Takahashi 2017, p. 77.
Sources
- Takahashi, T. (2017). Aircraft Performance and Sizing, Volume I: Fundamentals of Aircraft Performance. Momentum Press. ISBN 978-1-60650-684-4. Retrieved 2024-07-02.
- United States. Air Force (1960). Air Force AFM. Department of the Air Force. Retrieved 2024-07-02.
 | This aircraft-related article is a stub. You can help Wikipedia by expanding it. |